Allied Telesis AT-VIEW PLUS 3.2 DEVICE MANAGEMENT - Manual (Page 65)

Allied Telesyn AT-VIEW PLUS
DEVICE MANAGEMENT
Network Info
Displays network-related information such as the addresses of the default gateway and the
agents.
Note - The current firmware version does not allow the DNS Server and Default Domain
Name parameters to be configured. Attempting to configure these parameters will result
in the error message: "The error occurred with 'Set' operation. Error: gen Error.".
Chassis Info
Displays chassis information including the firmware information.
Note -The current firmware version does not allow the Power A Status and Power B
Status parameters to be configured. Attempting to configure these parameters will result
in the error message: "The error occurred with 'Set' operation. Error: gen Error.".
Line Card Info
Displays information for each line card including line card type and line card temperature.
MAC Address Table
Displays a list of static MAC address configured on the switch.
Note - Valid MIB Set values for the MAC Address Entry Status parameter are 'active',
'not in service' and 'destroy'. Attempting to set this parameter to any other value will result
in error message: "The error occurred with 'Set' operation. Error: bad value".
Reset
Resets the switch.
Telnet
Starts a Telnet connection to the switch.
WEB Browser
Connects to the switch's HTTP server.
Bridge Menu
From the Bridge menu, you can view and edit bridge information such as the forwarding
database and the spanning tree status.
Forwarding Database
Displays the Forwarding Database table.
Note - It may take some time to retrieve Forwarding Database information. As a result, all
the Forwarding Database parameters may reflect the value 'retry over occurred'. To avoid
this, click on File -> Property -> Polling options and set the Polling Interval parameter to
25 seconds or longer.
PN 613-50665-00 Rev C Page 65 of 294