Allied Telesis AT-SBx31CFC960 - Manual (Page 88)

Chapter 4: Safety Precautions and Site Preparation
88
Installation Tools and Material
Here are the tools and material you need to provide to install the product:
Installing the chassis in an equipment rack requires the following items:
 #2 Phillips-head screwdriver
 Six equipment rack screws
 Flat-head screwdriver
 #2 Phillips-head 10 inch-lbs torque screwdriver (optional)
Installing the grounding wire requires the following items:
 #2 Phillips-head screwdriver
 Crimping tool
 10 AWG stranded grounding wire
 #2 Phillips-head 20 inch-lbs torque screwdriver (optional)
Installing the AT-SBxPWRSYS1 DC Power Supply requires the following
items:
 Two 8 AWG power wires
 One 10 AWG stranded grounding wire
 8 mm wrench
 #1 Phillips-head screwdriver
 #3 Phillips-head screwdriver
 #3 Phillips-head 30 to 40 inch-lbs torque screwdriver (optional)
Installing the AT-SBx31CFC960 Controller Fabric Card and Ethernet line
cards require the following items:
 #2 Phillips-head screwdriver
 #2 Phillips-head, 5 inch-lbs torque screwdriver (optional)