Allied Telesis AT-SBx31CFC960 - Manual (Page 75)

SwitchBlade x3106 Chassis Switch and AT-SBx31CFC960 Card Installation Guide
75
The NET MGMT port has a standard RJ-45 8-pin connector and operates
at 10, 100, or 1000 Mbps in either half- or full-duplex mode. The cable
requirements for this port are the same as the ports on the AT-
SBx31GT24 Line Card, given in Table 13 on page 56. For the port pinouts,
refer to “Port Pinouts” on page 286.
The port uses Auto-Negotiation to set its speed. You may not disable Auto-
Negotiation. To avoid a speed or duplex mode mismatch, you should
connect the port only to a device that also uses Auto-Negotiation. If
connected to a network device that does not support Auto-Negotiation, it
defaults to 10 Mbps, half-duplex mode.
The wiring configuration of the NET MGMT port is set automatically with
automatic MDIX detection. You may not disable automatic MDIX
detection. For automatic MDIX detection to work successfully, the port
must be connected to a network device that also supports the feature. If
the NET MGMT port is connected to a network device that does not
support automatic MDIX detection, it defaults to MDIX. This may require
the use of a crossover cable. Here are the guidelines to choosing straight-
SNMPv1 and v2c Used to remotely manage the
chassis with SNMP.
SNTP client Used to set the date and time on
the controller card, from an NTP or
SNTP server on your network or
the Internet.
Syslog client Used to send the event messages
from the controller card to syslog
servers on your network for
storage.
TACACS+ client Used with a TACACS+ server on
your network for remote
management authentication.
Telnet server Used to remotely manage the
chassis with a Telnet client.
TFTP client Used with a TFTP server on your
network to download files to or
upload files from the controller
card.
TRACEROUTE Used to determine the
intermediate nodes (or hops) of
network paths.
Table 21. Management Features Requiring Network Access (Continued)
Feature Description