Innovate Motorsports LogWorks 3 - Manual (Page 128)

LogWorks3_Manual_1.01.doc - 128 -
11.3 LogWorks built-in chart calculations
These are the calculations built into LogWorks for calculating with charts. Check on the Innovate
Motorsports web site (
www.Innovatemotorsports.com ) for additional calculations as they
become available.
11.3.1 Fueling calculations
Fuel map from measured AFR and target AFR
Requires a current fuel map as input chart (user sub-chart) and a target AFR sub-chart.
The current fuel map values are assumed to increase linearly with injector timing, where 0 means
no injection (injector cut off).
11.4 Library file format
If you feel the need to edit the libraries directly with a text editor, this section shows the file
format. All libraries have the same basic format. Irrespective if it is a chart library, trace library or
search library.
The library managers use special comments in the formulas to identify individual formula entries.
These special library comments use a double comment marker (##) at the beginning of a text
line, followed by the text.
11.4.1 Name comment
Format:
##Nformulaname
The comment starts with ##N, followed immediately by the name of the formula. This is a
required comment. The Library managers identify formulas as the text between formula name
comments. This means a formula entry starts with the formula name and ends at the beginning of
the next formula name or the end of the text file.
11.4.2 Category comment
Format:
##Cformulacategory
This comment is optional and, if used, follows the Name comment. The comment starts with ##C,
followed immediately by the category used for the formula.