HP Integrity rx4610 Server - Manual (Page 99)

Chapter 8 Server Management Boards
91
Figure 8-5. Remove the Sideplane
Installing the Sideplane Board
To install the Sideplane board, complete the following steps:
1. Observe all safety and ESD precautions for handling electronic
components.
2. Install the Sideplane on to the mounting plate by tightening the two
mounting plate screws.
3. Lower the board into the side of the chassis, and slide it toward the rear of
the chassis back into position. The front lower corner of the board is the
rotation point you should use when positioning the board into place.
4. Tighten the captive thumbscrews on Sideplane to secure it to the chassis.
5. Reinstall the Power Distribution Board (T-Docking) as described in
“Installing the Power Distribution Board (T-Docking)”.
6. Reinstall the I/O Baseboard as described in “Installing the I/O Baseboard”.
7. Reinstall the Processor/Memory Complex as described in “Installing the
Processor/Memory Complex” in Chapter 5.