HP Integrity rx4610 Server - Manual (Page 129)

Chapter 10 Configuring the HP Server
121
DPC/LAN (Direct Platform Control/LAN) Setup
The Direct Platform Control (DPC)/ Local Area Network (LAN) setup page lets
you configure the following BMC LAN-Alert features.
DPC/LAN Feature Description
LAN Access Mode Sets the remote access mode. The choices are:
• Disabled. A remote system cannot initiate
a LAN session.
• Enabled. A remote system can initiate a
LAN session regardless of system state or
health.
• Restricted. Control operations, such as
power down, front panel NMI, and reset
cannot be performed.
Host IP Address The Host IP Address is the logical or Internet
Address of this server. You must enter the IP
address if DHCP is disabled (see the DHCP
option below). Enter the IP address as dotted
notation. Example: 192.168.0.2
Subnet Mask The Subnet Mask is the logical or Internet
address of this server's subnet. The mask is used
to determine if the alert destination is in the local
subnet or another subnet relative to the server.
You must enter the subnet mask if DHCP is
disabled (see the DHCP option below). Enter the
IP address as dotted notation. Example:
255.255.0.0
Gateway IP Address This is the IP address of the gateway, or router
system for the subnet. It is required when DHCP
is disabled (see the DHCP option below). Enter
the IP address as dotted notation. Example:
192.168.0.2