HP Integrity rx4610 Server User Manual
Page 75
Chapter 6
Installing an Additional Processor
67
Installing the Board in a System with Two Microprocessors
When installing a board with two microprocessors, complete the following
procedure:
1. Place the bottom half of the Processor/Memory Complex on a clean
ESD-protected work surface. The bottom half has wider rails as compared
to the top half. Be sure that the rail side of the complex is in contact with
the work surface.
2. Carefully place the Processor Baseboard topside up into position on the
bottom half of the Processor/Memory Complex.
3. Place the top half of the Processor/Memory Complex over the Processor
Baseboard. Be sure that the guide pin relations are correct. The Processor
Baseboard should be between the two Processor/Memory Complex halves.
4. Snap shut the four plastic latches that secure the two halves of the
Processor/Memory Complex together.
5. Tighten the two captive screws that help secure the Processor Baseboard to
the Processor/Memory Complex.
6. Carefully turn the Processor/Memory Complex over so that you can work
on the underside.
7. Install the CPU thermal dummies into the bottom half of the
Processor/Memory Complex as described in “Installing a CPU Thermal
Dummy” in Chapter 6.
8. Install the memory board into the bottom half of the Processor/Memory
Complex as described in “Removing and Installing Memory Boards” in
Chapter 5.
9. Install the triple beam and metal baffle.
10. Carefully turn the Processor/Memory Complex over so that you can work
on the topside.
11. Install the processors and power pods into the top half of the
Processor/Memory Complex as described in “Installing an Additional
Processor” in Chapter 6.
12. Install the triple beam and metal baffle.
13. Install the memory board into the top half of the Processor/Memory
Complex as described in “Removing and Installing Memory Boards” in
Chapter 5.
14. Install the Processor/Memory Complex into the server as described in
“Installing the Processor/Memory Complex” in Chapter 5.