HP Integrity rx4610 Server - Manual (Page 77)

69
7 Installing Accessory Boards
Introduction
The HP Server has ten I/O expansion slots available. PCI slots P1-P2 are
64-bit/33 MHz non-Hot Plug I/O expansion slots. PCI slots P3-P10 are 64-bit/66
MHz PCI Hot Plug I/O expansion slots . The PCI expansion slots are contained in
four PCI segments:
• F16, 0 provides for PCI slots 1 and 2, video, and the PXB that controls the
Super I/O functions.
• F16, 1 provides for PCI slots 3 through 5 and the dual-channel LVDS
controller.
• F16, 2 provides for slots 6 through 8.
• F16, 3 provides for slots 9 and 10.
Tested PCI Boards
For a list of tested PCI boards, check for compatibility in the Hardware Tested
Products list for the HP Server under the Service and Support topic for the specific
NOS used in the HP Server at HP’s web site:
http://www.hp.com/
CAUTION Some accessory board outputs may exceed U.S. National
Electrical code (NFPA 70) Class 2 or limited power source
limits and must use appropriate interconnecting cabling in
accordance with the National Electrical Code. (All
Hewlett-Packard boards comply with Class 2.)
Also refer to the Readme file and Chapter 10, "Configuring the HP Server," for
instructions.