HP Integrity rx4610 Server - Manual (Page 24)

Chapter 2 Opening and Closing the HP Server
16
Figure 2-2. Removing the Cover
9. Lift the top cover off the chassis.
Replacing the Top Cover
To replace the cover, complete these steps:
1. Provide ESD protection by wearing an antistatic wrist strap attached to
chassis ground of the system when handling components.
2. Before installing the top cover, check that you have not left loose tools or
parts inside the system.
3. Check that cables, add-in boards, and other components are properly
installed.
4. Make sure that the 120 mm fan cover is lifted and open.
5. Fold the rear part of the top cover open and set it down on the chassis,
aligning the hooks on both sides of the front half of the cover.
6. Place your hands on the sides of the chassis near the hinge of the rear part
such that your thumbs can aggressively slide the entire top cover toward
the front of the chassis. Sliding the cover in this direction engages the
hooks on both sides of the top cover into the chassis housing.