HP Integrity rx4610 Server - Manual (Page 39)

Chapter 4 Installing Mass Storage Devices
31
Figure 4-1. Removing a Hard Disk Drive
4. Carefully slide the assembly out of the bay, and place it on an antistatic
surface.
Installing a Hard Disk Drive
Hard disk drives are packaged in their drive carriers for immediate installation.
They require no assembly and may be installed without the use of any tools. To
install the hard disk drive, complete the following procedure:
1. Remove the plastic bezel on the front of the server.
2. Orient the new drive’s carrier and drive assembly in front of the bay guide
rails so that the latch is toward the top. Make sure that the carrier is placed
correctly into the guide rails to avoid damage.
CAUTION Do not press on the perforated metal bracket of the carrier
when you push the assembly into the bay, or you may damage
the metal fingers of the bracket.