HP Integrity rx4610 Server - Manual (Page 70)

Chapter 6 Installing an Additional Processor
62
Figure 6-5. Inserting a CPU Thermal Dummy
2. Secure the triple beam into place by tightening the captive screws on top of
the beam and then the four thumbscrews on the end of the beam.
3. Insert the sheet metal baffle located at the front of the processors or CPU
thermal dummies in the Processor/Memory Complex. To insert the baffle,
press the flexible retaining tabs in as you slide the baffle into place
4. Insert the Processor/Memory Complex into the chassis as described in
Chapter 5, “Installing the Processor/Memory Complex.”
Installing the Processor Baseboard
The Processor Baseboard resides between the two halves of the
Processor/Memory Complex. Removal of the Processor Baseboard involves
disassembly of the entire Processor/Memory Complex.
The board can accommodate one to four processors and two memory boards. If
your server does not have three or four processors, the underside of the Processor
Baseboard will have CPU thermal dummies in place of the processors and power
pods. These assemblies are easily removed when you lift the triple beam off the
board.