HP Integrity rx4610 Server User Manual
Page 73
Chapter 6
Installing an Additional Processor
65
NOTE
Securing the triple beam into position without the
microprocessors and power pods reduces the possibility of
stress occurring on the Processor Baseboard when you install
microprocessors and the memory board on the topside.
8. Secure the triple beam by tightening the four thumbscrews on the ends of
the beam. Do not tighten the captive screws on the top of the triple beam
at this time.
9. Carefully turn the Processor/Memory Complex over so that you can work
on the topside.
10. Install the processors and power pods into the top half of the
Processor/Memory Complex as described in “Installing an Additional
Processor” in Chapter 6.
11. Install the triple beam.
12. Insert the sheet metal baffle located to the front of the processors or CPU
thermal dummies in the Processor/Memory Complex. To insert the baffle,
press the flexible retaining tabs in as you slide the baffle into position.
13. Install the memory board into the top half of the Processor/Memory
Complex as described in “Removing and Installing Memory Boards” in
Chapter 5.
14. Carefully turn the Processor/Memory Complex over so that you can work
on the underside.
15. Remove the triple beam by first loosening the four thumbscrews found on
the ends and then the captive screws found on the top of the triple beam.
Lift the triple beam off the complex.