HP Integrity rx4610 Server User Manual
Page 130
Chapter 10
Configuring the HP Server
122
DPC/LAN Feature
Description
Alert IP Address
The Alert IP Address is the logical or Internet
address of the system(s) to which an Alert
message will be sent. For a single node
destination, enter the unicast or specific IP
address. For an alert to be broadcast within a
particular subnet, enter the subnet IP address.
Enter the IP address as dotted notation. Example:
192.168.0.2
SNMP Community String
Specify the SNMP Community String for the
community field in the Header section of the
SNMP trap sent for a LAN alert. The default
string is "Public". The string must be 5 to 16
characters long.
Set Password
If set, this password restricts DPC LAN access.
Select the Set Password button to display the
password setup page for clearing or setting the
password. The password setup page consists of
two edit boxes, one to enter a password, another
to confirm, and an
already exists, both of the edit boxes display
"********".
Valid characters for this password are any ASCII
values [32-126] (the characters space through
tilde, or ' ' through '~'). The maximum length
allowed is 16 characters.
To clear the old password, clear both edit boxes
by selecting each box and pressing the
key. To set a new password,
enter the new password in both of the edit boxes.
Select the
the previous setup page. You must select
in the previous setup page to clear or set
the new password to the BMC.
DHCP
Enables or disables the Dynamic Host
Configuration Protocol (DHCP). If DHCP is
enabled, the server automatically assigns the Host
IP address, Gateway IP address and Subnet Mask.
If DHCP is disabled, you must enter the Host IP
address, Gateway IP address, and Subnet Mask.