HP Integrity rx4610 Server - Manual (Page 140)

Chapter 10 Configuring the HP Server
132
Table 10-7. BIOS Setup System Management Screen Menu Items
Menu Item Default Value Description
Console Redirection N/A Selecting this option allows you to
configure for console redirection
Service Boot [Disabled]
Enabled Enabling this item will allow you to
boot into Service Partition Boot mode.
The item will be automatically reset to
“Disabled” on the next system boot.
Exit
Table 10-8 describes the menu items available on the Exit screen. Default values
appear in brackets.
Table 10-8. BIOS Setup Exit Screen Menu Items
Menu Item Description
Exit Saving Changes Lets you exit the system setup and save your changes in
CMOS. Clicking on the menu item offers a prompt for
which you can answer Yes or No. Either response causes
you to exit the setup utility.
Exit Discarding Changes Lets you exit the system setup and discard your changes.
Clicking on the menu item offers a prompt for which you
can answer Yes or No. Either response causes you to exit
the setup utility.
Load Setup Defaults Lets you load setup with the factory defaults. Clicking
on the menu item offers a prompt for which you can
answer Yes or No. You do not exit the setup utility.
Load Custom Defaults Lets you load setup with custom defaults. Clicking on
the menu item offers a prompt for which you can answer
Yes or No. You do not exit the setup utility.
Save Custom Defaults Lets you save the current set of values into a file that you
could later load using the Load Custom Defaults menu
item. Clicking on the menu item offers a prompt for
which you can answer Yes or No. You do not exit the
setup utility.
Discard Changes Lets you discard the changed values you have
accumulated during this setup session. Clicking on the
menu item offers a prompt for which you can answer Yes
or No. You do not exit the utility.