HP Integrity rx4610 Server - Manual (Page 98)

Chapter 8 Server Management Boards
90
Loosen the three captive thumb screws.
Figure 8-4. Removing the Screws from the Sideplane
6. Slide the Sideplane towards the front of the chassis. As you slide the
board, keep the front bottom edge of the board in contact with the carrier
tray as the board is rotated up and out of the chassis.
7. Tilt the Sideplane up and out of the chassis.
8. Remove the two retaining screws from the Sideplane to remove the
mounting plate.