HP Integrity rx4610 Server - Manual (Page 96)

Chapter 8 Server Management Boards
88
7. Rotate the levers downward to press the I/O Baseboard securely into the
Sideplane.
8. Connect the Internal SCSI cable to the front of the I/O Baseboard.
9 Install the plastic shield over the I/O Baseboard and tighten the two
thumbscrews that secure the shield and the I/O Baseboard in the chassis.
10. Connect the PCI LED cable.
11. Install the DC-DC converters on the Sideplane. The voltages are marked
on the power supplies and near the sockets on the baseboard.
12. Install the protective cover over the DC-to-DC converters on the
Sideplane, and secure the cover with the thumbscrew.
13. Connect the cable to the external SCSI port at both ends: one to the I/O
Baseboard and the other secured to the rear of the chassis with the captive
thumbscrew.
14. Install the Legacy I/O board and cables as described in “Installing the
Legacy I/O Board”.
15. Install the non-hot plug PCI and hot plug PCI adapter boards as described
in “Installing Accessory Boards” in Chapter 7.
16. Install all PCI slot plastic dividers (I/O Card Dividers) as required.
17. Install the top cover as described in “Replacing the Top Cover” in
Chapter 2.
18. Attach the non-hot plug PCI adapter board cover and secure it with its
screw.
19. Close the PCI I/O access door, and secure it with the two captive
thumbscrews.
20. Reconnect the power cables.