HP Integrity rx4610 Server - Manual (Page 230)

Appendix A Specifications
222
Configuring FWH Programming
Jumper block J4A1 allows you to set the FWH programming at 12 Volts. By
default, FWH programming is configured for 3.3 Volts.
1 J4A1
A
1 J4A1
B
Figure A-16. Configuring FWH Programming
Jumper diagram labeled:
A. FWH Programming at 12 Volts
B. FWH Programming at 3.3 Volts (Default Setting)
Configuring Recovery Boot
Jumper block J7A1 controls whether the system attempts to boot using the BIOS
programmed in flash memory. By default, the system does not perform a
recovery boot using this BIOS.
B
1
J7A1 J7A1
A
1
Figure A-17. Configuring the Recovery Boot Process
Jumper diagram labels:
A. Default Setting
B. Use the BIOS Programmed in Flash Memory During a Recovery Boot
Procedure