Backup & restore (administration), Backup and restore (administration), Recommendations – HP StoreOnce Backup User Manual
Page 93: Backing up the configuration file
NOTE:
If there is an issue with the ticket being generated, a partial ticket may be created.
4.
Click Download Support Ticket to save the file to disk.
Backup & Restore (Administration)
This tab allows you to save the HP StoreOnce Backup System's configuration settings by
downloading them to the host system. If the HP StoreOnce Backup System or the host is repaired
or replaced, the configuration settings can be restored. It is also possible to restore an HP StoreOnce
Backup System to factory settings, if a critical failure cannot be resolved by any other means. This
should normally only be done, if advised to do so by HP Customer Support.
Recommendations
Certain combinations of hardware failure will result in the need to recover configuration settings.
It is strongly recommended that you export the configuration file:
•
Once you have initially configured the HP StoreOnce Backup System and the configuration
is stable
•
Whenever you change the configuration
•
Before you upgrade the software
•
Immediately after upgrading software
•
Before you change any hardware component
NOTE:
Configuratin files generated on old software will not be compatible after software upgrade,
so a new configuration file must be taken after software update.
Backing up the configuration file
1.
Click on Export to create the configuration file.
2.
At the prompt, select Save to disk.
Backup & Restore (Administration)
93