Fibre channel card leds, Capacity upgrade kit leds, Fibre channel card leds capacity upgrade kit leds – HP StoreOnce Backup User Manual
Page 119: Beacon mode
Beacon mode
The HP StoreOnce Backup System supports a Beacon LED sequence, which helps a user identify
which unit is being configured, if several are connected to the network. AL HP D2D4000 Series
Backup System also have a Beacon LED on the individual disks so that you can identify a specific
disk within the HP D2D.
Use the Network page of the Web Management Interface to turn Beacon Mode on and off for the
HP StoreOnce Backup System. This turns the Beacon LED on the front and the rear of the HP D2D
solid blue. If you do not switch off Beacon Mode, it will continue for 5 minutes. See also
. You can also switch Beacon mode on and off by pressing the LED on
the front panel.
Fibre Channel card LEDs
If you have the Fibre Channel version of the HP D2D, there are three LEDs adjacent to each FC
port.
Table 26 FC card LEDs
Activity
Amber LED
Green LED
Yellow LED
Power Off (OK)
Off
Off
Off
Power on before or after software initialization.
Awaiting HBA software initialization.
On
On
On
Power on after software initialization. Link not
initialized.
Flashing
Flashing
Flashing
software fault (OK)
Alternately flashing
Alternately flashing
Alternately flashing
Connected at 2 (HP D2D4300 Series only) or
1 (all other FC systems) Gb/s
On
Off
Off
Activity at 2 (HP D2D4300 Series only) or 1
(all other FC systems) Gb/s (OK)
Flashing
Off
Off
Connected at 4 (HP D2D4300 Series only) or
2 (all other FC systems Gb/s
Off
On
Off
Activity at 4 (HP D2D4300 Series only) or 2
(all other FC systems)Gb/s (OK)
Off
Flashing
Off
Connected at 8 (HP D2D4300 Series only) or
4 (all other FC systems) Gb/s
Off
Off
On
Activity at 8 (HP D2D4300 Series only) or 4
(all other FC systems) Gb/s (OK)
Off
Off
Flashing
Capacity upgrade kit LEDs
There are three LEDs on the front of the Capacity Upgrade Kit.
Fibre Channel card LEDs
119