HP StoreOnce Backup - Manual (Page 86)

Date & Time settings
These fields provide the ability to manually set the date and time. They can only be edited if the
NTP process is disabled.
Date Display format
Click Edit to change the way the date format is displayed in Replication and System Event logs.
Select the desired format from the drop-down menu and click Update.
Network Time Protocol (NTP) settings
Network Time Protocol (NTP) provides support for automatic time synchronization. If you are using
an Active Directory Service domain controller, it is important to synchronize the StoreOnce
appliance's real-time clock with the same time source as that of the Active Directory Server.
NOTE: If you enable NTP, you cannot configure date and time manually and you must set the
Current Location correctly to ensure that local time is correct
•
Check the NTP Enabled box and provide the IP address or fully qualified domain name of an
NTP server on the local network.
•
It is possible to synchronize the HP StoreOnce Backup System with up to three NTP servers.
If you are using Windows Active Directory, one of these should be either the domain controller
server or an NTP server that the domain controller is also using to synchronize its time. Providing
multiple NTP servers ensures that a single server failing or getting out of sync will not affect
the time on the HP StoreOnce system.
•
Be sure to check the box next to each of the servers to enable.
IMPORTANT: If the NTP server (for automatic date and time update) fails to connect to the server
for any reason, it will fail and stop the NTP server. If this happens an email alert will be sent and
the user must manually restart NTP from the Web Management Interface.
Daylight Saving
By default, the HP StoreOnce Backup System does not make any automatic adjustments for daylight
saving time. Use this section to enable daylight saving and also view the current time zone/location.
86 Administration