HP StoreOnce Backup - Manual (Page 37)

SNMP (Configuration)
This feature provides an HP StoreOnce Backup System with the ability to act as a Network Element
in an SNMP network so that it can communicate effectively with Network Management Stations
using SNMP (Simple Network Management Protocol). You use the SNMP tab to enable this feature
and configure various settings, as described below.
The StoreOnce implementation of SNMP is compatible with and has been tested with HP System
Insight Manager (HP-SIM).
Procedure 4
1. To enable SNMP, click on Edit and check the SNMP Enabled box.
2. Make any changes to the default parameters, as appropriate. See also SNMP
parameters (page 38) .
3. Click Add in the Destinations section to specify the IP Address(es) of the SNMP management
host(s) that will be monitoring the HP StoreOnce Backup System. If you do not specify any
destinations, events will be reported to everybody on the network. (To remove an SNMP host,
simply select its IP address and click Remove.)
SNMP (Configuration) 37