How do i know a disk has failed, Summary page information – HP StoreOnce Backup User Manual
Page 137
How do I know a disk has failed?
The Disk online LED (1) on the failed disk shows amber.
Figure 27 Drive LEDs
NOTE:
For more information about these LEDs refer to
.
Identifying a failed disk on the Web Management Interface
The Web Management Interface identifies failed or predictive failed disks.
•
HP D2D4300 and HP D2D4100 Series Backup Systems operate correctly with up to two
failed disks on the HP D2D and up to two failed disks in any Capacity Upgrade Kit that is
installed.
•
HP D2D2500 Series Backup Systems operate correctly with one failed disk.
It is important to replace a failed or predictive failed disks as soon as possible. Any subsequent
disk failure will result in complete data loss.
NOTE:
The first disk (HP D2D4300 Series) or the 12th disk (HP D2D4100 Series) on the internal
shelf and the 12th disk on any expansion shelves are the online spare disks. If a disk fails, the
online spare disk will immediately be used to replace it. The RAID rebuild process occurs
automatically. The failed disk should always be replaced as soon as possible.
Summary page information
Look at the Summary page. For example:
•
HP D2D4100/4300 Series: If it shows see that RAID is building, but is fully operational and
that Storage needs attention, this probably means that a disk has failed and the online spare
is being used. The Storage (Status) tabs will provide more information.
•
HP D2D2500 Series: If you can see that RAID status has failed, but it is recoverable, this
means that one disk has failed.
,
How do I know a disk has failed?
137