HP StoreOnce Backup - Manual (Page 143)

Figure 38 Disk numbering of the internal shelf (HP D2D4300 Series)
NOTE: The red lettering indicates the disk number on the Web Management Interface.
Figure 39 Disk numbering of expansion shelves (HP D2D4300/4100 Series)
3. Remove the disk.
•
Press the hard disk carrier button (1) to release the ejector lever.
•
Pull out the disk carrier handle (2) and slide the hard drive assembly (3) out of the drive
bay. Be sure to support the drive when pulling it out of the cage.
Figure 40 Removing the hard drive (example shows D2D4100 Series)
4. Replace the failed disk with the new disk.
Push the hard drive assembly (1) into the drive bay until it stops and press the HDD carrier
latch (2) inward until it clicks.
Replacing a hot-plug hard disk 143