HP Integrity NonStop H-Series - Manual (Page 97)

SNAX/CDF
Subsystems
5–12 098571 Tandem Computers Incorporated
States Table 5-9 shows how DSNM reports SNAX/CDF subsystem states.
Table 5-9. How DSNM Reports SNAX/CDF Subsystem States
DSNM Object State SNAX/CDF Subsystem State
UP STARTED
PENDING STARTING
STOPPING
ABORTING
DOWN DEFINED
STOPPED
Note Table 5-9 is valid for the DSNM STATUS command. Because of the way that subsystems are
implemented, the NetStatus product and the DSNM INQUIRE command can report objects as either up or
down, which the DSNM STATUS command reports as pending.
The DSNM INQUIRE command and the NetStatus product log changes only for PROCESS, CDRM,
LINE, and PU objects.
Effects of the Hierarchy
Modifier
Hierarchy modifiers are only valid for the PROCESS, CDRM, and LINE object types.
Table 5-10 shows the effects of the hierarchy modifier when it is applied.
Table 5-10. Hierarchy Modifiers in the SNAX/CDF Subsystem
Object Type Hierarchy Modifier DSNM applies the command to:
PROCESS ALL The specified object and all subordinate objects. Since the
PROCESS object type cannot be aborted, ALL cannot be
combined with PROCESS in the START or ABORT commands.
ONLY Only the specified objects. Since the PROCESS object type
cannot be aborted, ONLY cannot be combined with PROCESS
in the START or ABORT commands.
SUBONLY Only the objects that are subordinate to the specified objects.
CDRM ALL The specified CDRMs and all subordinate CDRSCs.
ONLY Only the specified CDRMs.
SUBONLY Only the CDRSCs that are subordinate to the specified
CDRMs.
LINE ALL Only the specified PUs (There are no subordinate objects.)
ONLY Only the specified PUs.
SUBONLY (There are no subordinate objects.)