HP Integrity NonStop H-Series - Manual (Page 123)

BREAK Command
NonStop NET/MASTER MS Interface
098571 Tandem Computers Incorporated 7–5
BREAK Command Use the BREAK command to send a BREAK message for immediate processing by the
utility session. The following command is equivalent to pressing the BREAK key if
you were running the utility yourself. Many conversational utilities interpret the
BREAK message as a request to abandon current operations.
OPSYS BREAK session
session
is the name of an existing utility session to which a BREAK message is sent. The
session name was created with the SEND command that established the utility
session. See “SEND Command” later in this section for information on utility and
session names.
Considerations
The BREAK message is sent to the utility immediately. If the utility session is
currently processing a command, the command is preempted.
Examples
The following command immediately sends a break message to the FUP utility
session:
OPSYS BREAK FUP