HP Integrity NonStop H-Series - Manual (Page 118)

Define Process Commands
NetCommand Interface
6–10 098571 Tandem Computers Incorporated
Define Process
Commands
The Tandem VIEWPOINT product includes the Define Process command library,
which is a set of commands used to define, start, stop, and undefine processes in any
node to which the user has access.
If VIEWPOINT is installed on your node, the commands are also available within
NetCommand. Refer to the VIEWPOINT Manual for detailed instructions on using the
Define Process commands.
Commands available within the VIEWPOINT environment are:
DP defines a process.
PINFO displays information about a process .
POUT displays the contents of the output queue.
PSHOW shows the input or output queue.
PSTART starts a define process.
PSTOP stops a define process.
TOSS clears the input or output queue.
UNDP undefines a process.
WAIT waits for output.
WAITREADY synchronizes with a process.
Check with your system manager to find out whether you are authorized to use the
Define Process commands, and which of the commands you can use.
You can obtain help for the Define Process (DP) commands by issuing the command
shown in the following box.
PHELP [ command]
command
is one of the DP commands. If the command is omitted, general help about DP
commands is displayed.
Not all options of the DP command are supported in NetCommand. For help on the
DP command as implemented in the NetCommand environment, issue the command
shown in the following box.
HELP DP