HP Integrity NonStop H-Series - Manual (Page 106)

X25AM
Subsystems
098571 Tandem Computers Incorporated 5–21
Effects of the Hierarchy
Modifier
Table 5-18 shows the effects of the hierarchy modifier when it is applied to the various
object types in this subsystem. The default value is ALL.
Table 5-18. Hierarchy Modifiers in the X25AM Subsystem
Object Type Hierarchy Modifier DSNM applies the command to:
LINE ALL The specified lines and all subordinate SUs
ONLY Only the specified lines
SUBONLY Only the SUs subordinate to the specified lines
SU ALL Only the specified SU (there are no subordinate
objects)
ONLY Only the specified SUs
SUBONLY (there are no subordinate objects)
Control Commands The DSNM START, STOP, and ABORT commands are similar to the SCF START,
STOP, and ABORT commands.
The INFO Command When the INFO command is issued against an X25AM object, it produces much the
same information as the SCF INFO DETAIL command. Refer to the SCF Reference
Manual for X25AM for more information.
The STATISTICS Command When the STATISTICS command is issued against an X25AM object, it produces much
the same information as the SCF STATS command, but in a different format. Refer to
the SCF Reference Manual for X25AM for more information.