HP Intelligent Management Center Licenses - Manual (Page 61)

j. Under CE route, type destination IP/mask 0.0.0.0/0, click Add, and click Next.
k. Select Deploy Immediately, and click OK.
6. Deploy spoke sites in a VPN.
a.
Click VPN Resources >SA Management in the navigation tree and click Add.
b. Click PE Device List and then select PE 2. Click OK.
c. Click Select VPN. Select the newly added VPN VPN(100:1,100:2) in step 4, and click
OK.
d. Click Next, and select the newly added SC(100:1,100:2). Add by Spoke, and click
Next.
e. Under PE Configuration select Eth2/0 from the Interface Description drop-down list, and
then type PE interface IP/mask 10.1.2.1/30.
f. Under CE Configuration, select CE2 from the Device Name drop-down list, select Eth1/0/1
from the Interface Description drop-down list, and then type CE interface IP/mask
10.1.2.2/30. Click Next.
g. Type the VRF name vpnSpoke and RD value 10.172.152.2:100.
h. If there is no routing protocol running between PE 1 and CE 1, select Configure route,
and then click Next.
i. Under PE route, type the AS number 65001, and destination IP/mask x.x.x.x/x (IP address
of the subnet where CEs reside). Click Add.
j. Under CE route, type the destination IP/mask 0.0.0.0/0, click Add, and click Next.
k. Select Deploy Immediately, and click OK.
l. Perform the same operations on PE 3 and PE 4.
7. Query topology.
a.
Click MPLS VPN Manager > Global Topology in the navigation tree, and you can see the
newly added links in the global topology in the MVM.
b. Click VPN Resources > VPN Management in the navigation tree to enter the VPN List
page. Select the newly discovered VPN(100:1,100:2) to query the corresponding access
topology and service topology.
Precautions
•
If routing protocols exist between PEs and CEs, you do not need to select Configure route.
•
After you have configured the static route for a PE or CE, if you return to the Interface
Configuration page to modify the interface IP address, the configured static route must be
re-added.
•
If you do not select Deploy Immediately, the links are displayed as dotted line in the global
topology, and you can right-click to select Deploy Immediately or select Deploy Immediately
on the SA Management page.
•
If a device has been configured an AS number, you are not allowed to modify it in the MPLS
VPN Manager system.
•
The newly configured VRF name cannot be the same as that existing on the current device;
otherwise, it indicates that the original configuration will be re-used.
Remove a link from a VPN
Scenario description
A company has established a full-mesh VPN network and is managing and maintaining the network
through MVM. Because of changes of their services, a site needs to be removed from the current
VPN network.
Typical applications 61