HP Intelligent Management Center Licenses - Manual (Page 24)

VLL Deployment
This function helps you configure and deploy a VPN of VLL type. After you configure a VLL VPN,
if you do not deploy the VPN configuration immediately, a deployment task in state of "undeployed"
is added on the deployment task list. If you deploy the VPN configuration immediately, a deployment
task in state of "deploying" is added on the deployment task list. After the deployment, you can
view the deployment result.
Configuration procedure
1. Define VPN.
This function allows you to configure a VPN's basic information, including VPN name, PW
ID, PW transport mode, audit interval, VPN description, and contact information.
Precautions
•
Valid characters in a VPN name are letters, digits, and underscores.
•
PW ID is generated randomly. You can modify it in the range 1 to 4294967295.
•
PW transport mode can be VLAN or Ethernet. VLAN is the default.
•
Audit interval ranges from 0 to 24 and defaults to 24. A value of 0 means no audit.
•
Contact is the current login user by default.
2. Local PE configuration.
This function allows you to configure the local PE and interface information for a VLL VPN,
including PE name, UNI interface, service instance, bandwidth, encapsulation type,
encapsulation VLAN, access type, and CE device.
a.
For PE configuration, click Select following the interface description, and then on the
pop-up page, select a PE and an interface. If you select a Layer 2 interface, you must
select the encapsulation type and enter the service instance ID and bandwidth.
b. For CE configuration, click Select following the device label, and then select a CE device.
If you do not select a CE device, the system automatically adds a VCE.
Precautions
•
You can only type a number in the range 1 to 4094 in the service instance text box.
•
You can only type a number in the range 1 to 1000 in the bandwidth text box.
•
Encapsulation VLAN IDs are in the range 1 to 4094. You can specify one or more VLAN
IDs or VLAN ID ranges. To specify a VLAN range, use a hyphen (-) between the start and
end VLAN IDs of the range. To specify multiple VLAN ranges, use a dot (,) to separate
two VLAN ranges. The specified VLAN ID(s) and VLAN ID range(s) must be in the
ascending order. For example: 2, 4-6, 8-10
•
The access type can be VLAN or Ethernet. VLAN is the default.
•
If the encapsulation type is S-VID or S-VID Only Tagged, you must enter the encapsulation
VLAN IDs.
3. Remote PE configuration.
This function allows you to configure the peer PE and interface information for a VLL VPN,
including PE name, UNI interface, service instance, bandwidth, encapsulation VLAN,
24 L2VPN Manager