HP Intelligent Management Center Licenses - Manual (Page 26)

Steps to configure the PE information
a. Click the Add button in the PE device list area, and then on the pop-up page, select one
or multiple PE devices.
b. Click the Modify icon in the Configuration column, and then on the pop-up page, select
one or multiple PE interfaces.
Precautions
•
For service instance, you can only type a number in the range 1 to 4094.
•
For bandwidth, you can only type a number in the range 1 to 1000.
•
Encapsulation VLAN IDs are in the range 1 to 4094. You can specify one or more VLAN
IDs or VLAN ID ranges. To specify a VLAN range, use a hyphen (-) between the start and
end VLAN IDs of the range. To specify multiple VLAN ranges, use a dot (,) to separate
two VLAN ranges. The specified VLAN ID(s) and VLAN ID range(s) must be in the
ascending order. For example: 2, 4-6, 8-10
•
The access type can be VLAN or Ethernet. VLAN is the default.
•
If you do not select a CE device, the system automatically adds a VCE.
•
If the encapsulation type is S-VID or S-VID Only Tagged, you must enter the encapsulation
VLAN IDs.
•
If the PE device you select when you configure AC information is not in the PE device list,
the system automatically adds the PE to the PE device list.
3. Configuration summary.
This function displays the configuration information to be deployed to PE devices.
a.
Select Deploy Immediately, and click OK.
Precautions
•
The configuration commands are generated by the system automatically. You cannot
modify them.
•
If you do not select Deploy Immediately, the system only creates the VPN and adds an
"Undeployed" deployment task to the deployment task list. You can deploy the
configuration later. If you select Deploy Immediately, the system deploys the configuration
to the devices immediately. A CE device and a link between the CE device and PE device
are added on the L2VPN Manager and the deployed configuration is recorded on the
related devices.
Undeployment
This function is used to undeploy the configuration information from devices. Undeployment supports
three operations: undeploy VPNs, undeploy PEs, and undeploy AC links.
Undeploy an entire VPN
1. Select VPN.
a.
Click the Service tab on the top navigation bar, and then select VPN Deployment >
Undeploymentin the navigation tree to enter the undeployment page.
b. Click Select to select the VPN that you want to undeploy.
26 L2VPN Manager