HP Intelligent Management Center Licenses - Manual (Page 115)

Operation Procedure
1. Select the Service tab, and then click MPLS TE Tunnel Management in the navigation tree to
enter the MPLS TE tunnel list page.
2. Select the query type and input the query value.
3. Click Query.
Precautions
•
The input query value must match the selected query type. If you select to query by tunnel
name, you need to input the name or part of the name of a tunnel.
Add/modify tunnel
This function is used to add/modify an MPLS TE tunnel.
Operation Procedure
1. Select the Service tab, and then click MPLS TE Tunnel Management in the navigation tree to
enter the MPLS TE tunnel list page.
2. Click the Add button to enter the page for adding an MPLS TE tunnel or click the Modify icon
of a tunnel in the list to enter the tunnel modification page.
3. Configure the basic MPLS TE tunnel configuration information.
•
If you select Static CR-LSP for the Protocol parameter and click Next, you will enter the
static CR-LSP configuration page.
•
If you select RSVP-TE for the Protocol parameter and click Next, you will enter the basic
attributes configuration page.
Precautions
•
When modifying an MPLS TE tunnel, you cannot modify the selected device, tunnel name,
signaling protocol, and tunnel ID of the tunnel.
•
MPLS TE tunnel names and tunnel IDs on a device must be unique.
Parameters
•
Devices fall into centralized devices and distributed devices.
For a centralized device, the MPLS TE tunnel name is in the format of Tunnel+tunnel name. ◦
◦ For a distributed device, the MPLS TE tunnel name is in the format of Tunnel+slot
number+/+subcard number+/+tunnel name.
•
Protocol: Signaling protocol used to establish the MPLS TE tunnel, which can be static CR-LSP
or RSVP TE.
•
IP Address (A.B.C.D): IP address of the tunnel's headend.
Delete tunnel
This function is used to delete one or more MPLS TE tunnels.
Operation procedure
1. Select the Service tab, and then click MPLS TE Tunnel Management in the navigation tree to
enter the MPLS TE tunnel list page.
2. Select the tunnel(s) you want to delete and click Delete.
3. Click OK on the pop-up confirmation dialog box.
Using the MPLS TE manager 115