HP Intelligent Management Center Licenses - Manual (Page 23)

UNI interface, service instance, bandwidth, encapsulation type, encapsulation VLAN, access
type, and CE device.
Steps to configure AC information
a. Click Add in the AC list area, and then on the pop-up page, select a PE interface.
b. Type the service instance, encapsulation VLAN and bandwidth, and select the
encapsulation type and access type.
c. ClickSelect behind the CE Device text box, and then on the pop-up page, select a CE
device.
d. Click OK.
Steps to configure PE information
a. Click Add in the PE device list area, and then on the pop-up page, select one or multiple
PE devices.
b. On the PE device list, select one or multiple PE devices, click the Main NPE button, and
then on the pop-up page, select one PE device.
c. On the PE device list, select one or multiple PE devices, click the Backup NPE button, and
then on the pop-up page, select one PE device.
Precautions
•
You can only type a number in the range 1 to 4094 in the service instance text box.
•
You can only type a number in the range 1 to 1000 in the bandwidth text box.
•
Encapsulation VLAN IDs are in the range 1 to 4094. You can specify one or more VLAN
IDs or VLAN ID ranges. To specify a VLAN range, use a hyphen (-) between the start and
end VLAN IDs of the range. To specify multiple VLAN ranges, use a dot (,) to separate
two VLAN ranges. The specified VLAN ID(s) and VLAN ID range(s) must be in the
ascending order. For example: 2, 4-6, 8-10
•
The access type can be VLAN or Ethernet. VLAN is the default.
•
If you do not select a CE device, the system automatically adds a VCE.
•
If the encapsulation type is S-VID or S-VID Only Tagged, you must enter the encapsulation
VLAN IDs.
•
If the PE device you select when you configure AC information is not in the PE device list,
the system automatically adds the PE to the PE device list.
4. Configuration summary.
This function displays the configuration commands to be deployed to PE devices.
a.
Select Deploy Immediately, and click OK.
Precautions
•
The configuration commands are generated by the system automatically. You cannot
modify them.
•
If you do not select Deploy Immediately, the system only creates the VPN and adds an
"Undeployed" deployment task to the deployment task list. You can deploy the
configuration later. If you select Deploy Immediately, the system deploys the configuration
to the devices immediately. A CE device and a link between the CE device and PE device
are added on the L2VPN Manager and the deployed configuration is recorded on the
related devices.
Using L2VPN Manager 23