HP Intelligent Management Center Licenses - Manual (Page 21)

Operation procedure
1. Click the Servicetab on the top navigation bar, and then select VPN Devices > CE Devices in
the navigation tree to enter the CE list page.
2. Click the VLAN Mapping icon of a CE to enter the page for VLAN mapping list.
Add VLAN mapping
Use this function to add the VLAN mapping relation for all interfaces of a CE.
Operation Procedure
1. Click the Service tab on the top navigation bar, and then select VPN DevicesCE Devices in the
navigation tree to enter the CE list page.
2. Click the VLAN Mapping icon of a CE to enter the page for VLAN mapping list.
3. Click Add to enter the page for add VLAN mapping.
4. Click Select and on the pop-up page, select an interface, and then click OK.
5. Click Add in the VLAN mapping list.
6. In the pop-up window, type the source VLAN ID and Destination VLAN ID, and then click OK.
7. Repeat procedures 5 and 6 to add more relations.
8. Click OK on the add VLAN mapping page
Delete VLAN mapping
Use this function to delete the VLAN mapping relation for all interfaces of a CE.
Operation Procedure
1. Click the Service tab on the top navigation bar, and then select VPN DevicesCE Devices in the
navigation tree to enter the CE list page.
2. Click the icon of a CE to enter the page for VLAN mapping list.
3. Select one or more VLAN mapping relations you want to delete.
4. Click OK.
VPN deployment
The L2VPN Manager provides the VPN deployment function that allows for simple and user-friendly
operations. You do not need to go to different labs or use command lines to configure a VPN. This
greatly reduces the time and working load for maintenance.
VPN deployment consists of VPLS deployment, VLL deployment, PBB deployment, undeployment,
and deployment task management. VPLS/VLL/VBB deployments allow you to conveniently add PE
devices to a VPN in different ways and connect PEs with CEs. Undeployment allows you to remove
PEs from a VPN or remove links between PEs and CEs. Deployment task management allows you
to view the deployment tasks, modify a deployment task, and deploy the configuration in a task
to devices.
This function cannot be used when BGP VPN is selected on the global parameter configuration
page.
VPLS deployment
This function helps you configure and deploy a VPN of VPLS type. After you configure a VPLS VPN,
if you do not deploy the VPN configuration immediately, a deployment task in state of "undeployed"
is added on the deployment task list. If you deploy the VPN configuration immediately, a deployment
task in state of "deploying" is added on the deployment task list. After the deployment, you can
view the deployment result.
Using L2VPN Manager 21