HP Intelligent Management Center Licenses - Manual (Page 52)

•
CE 3: The management IP address is 10.172.6.1/32.
•
CE 4: The management IP address is 10.172.7.1/32.
Scenario analysis
MVM can monitor device roles in HoVPN on real time. Suppose that CE 1 and CE 3 need to
communicate with each other after MVM manages all the devices. Add Import RT value 1000:2
to the VRF instance vpnHub associated with interface Eth 1/0 on UPE 1 and add Import RT value
1000:2 to the VRF instance vpnHub1 associated with interface Eth 5/1 on UPE 2. You can use
MVM to audit configurations on the devices to know these configuration changes of the devices
in the VPN.
Operation procedure
1. Add device to the platform.
a.
Select Resource on the platform, click Resource Management > Add Device in the
navigation tree, type the IP addresses of SPE, UPE 1, UPE 2, and CE 1 through CE 3 and
the corresponding Telnet and SNMP parameters. Then click OK.
2. Import PE devices to the MPLS VPN Manager system.
a.
Select the Service tab on the platform page to enter MPLS VPN Manager system.
b. Click VPN Resources > Region Management in the navigation tree, and click Import Device
on the page of the selected area or subarea to enter the Import Device page.
c. On the Import Device page, click Select Device, and then select PE 1, PE 2, and PE 3,
which can be queried by device name, IP address, contact, location, device status and
device category. Then click OK.
d. Click OK.
3. Import CE devices to the MPLS VPN Manager system.
a.
Click VPN Devices > CE Device List in the navigation tree to enter the CE device list page,
and then click Import on the page.
b. Click Select to select the device to be imported, and then click OK.
c. Click the Please select CE type to be imported drop-down list to select the device type.
52 MPLS Manager