HP Intelligent Management Center Licenses - Manual (Page 90)

Deploy SA
Deploying SA for the specified PE device can implement both immediate deployment of SA
configuration and deployment of configurations of all SAs. SA configurations cannot only be
deployed on PEs but also on managed CEs.
Follow these approaches to enter the SA Management page.
•
Approach 1: Click the Service tab, click MPLS VPN Manager, and then click VPN Resources
> SA Managementin the navigation tree, and click Add on the SA Management page.
•
Approach 2: Select the PE device to be deployed in global topology, and right-click to select
Service Deploy.
Follow the six steps discussed below to deploy SA.
1. Select VPN the link belongs to and PE.
a.
Click Select PE, and then select a PE the link belongs to.
b. Click Select VPN, and then select a VPN the link belongs to.
Precautions
•
A VPN link can only belong to one VPN and the selected VPN must exist in the MVM. If
it does not exist, Add VPN first.
•
You can select an existing PE only, and the system automatically filters non-PEs on the
Select PE page.
2. Select the SC the link belongs to and the way the link is added to the SC.
a.
You can select multiple SCs in a VPN, or click Add SC to create an SC. Refer to Add SC
to create an SC.
b. Click Add by HUB or Add by Spoke.
c. Click Release SC to release the selected SCs in the SC list.
Parameters
•
The ways for a link to be added to the SCs in a VPN: Add by HUB and Add by Spoke.
If an SC is in a Full-Mesh network, a link can be added to the SC by Hub only; if the SC
is in a Hub-Spoke network, the link can be added to the SC by Hub or by Spoke.
•
Selected SC: All the SCs you select to be added and the join type are listed in table.
•
Every SC exists in the list of the SCs contained in a VPN, or in the SC list you select. Once
you select to add a link to one or multiple SCs by Hub or by Spoke, the corresponding
SC(s) will be automatically added to the SC list you select; once you select to release
SC(s) from the SC list you selected, the SC(s) will be added to the list of SCs contained
in the VPN.
3. Configure information of the interfaces on the PEs and CEs on the two ends of the VPN link.
Parameters
•
PE interface description: All the PE interfaces that are not associated with VRF are listed.
VPN links may exist or not exist on the interface associated with VRF in MVM. The
non-existent links do not need to be deployed and can be added to the VPN during auto
discovery process.
•
Create Non-managed CE automatically: If there is no available CE or non-managed CE
during service deployment, this function can automatically create a non-managed CE
which connects to the PE to complete service deployment operation.
•
Auto filter CE interface: If you have selected PE interfaces and CEs, CE interfaces which
are on the same subnet (IP addresses are different) with the PE interfaces will be
automatically filtered.
90 MPLS Manager