beautypg.com

Mpls te manager usage summary – HP Intelligent Management Center Licenses User Manual

Page 100

background image

Advanced RSVP TE Features

Device Features

This function allows you to perform device RSVP TE configurations on MPLS TE devices.

Interface Features

This function allows you to perform interface RSVP TE configurations on MPLS TE devices.

MPLS TE Tunnel Management

This function helps you establish MPLS TE tunnels, including static and dynamic tunnels.

Explicit Path Management

This function allows you to configure explicit paths for dynamic tunnels.

Protection Management

This function helps you with dynamic tunnel protection, including path protection and node
protection.

Traffic Access Management

This function allows you to manage traffic of MPLS TE tunnels to keep the system performance
stable.

MPLS TE manager usage summary

For configuration procedures of the MPLS TE services, refer to the operation guide part of the MPLS
TE manager help.

Follow the steps below to quickly configure and use the MPLS TE manager.

1.

Import device.

Import MPLS TE-capable devices to the MPLS TE manager system. This step is the prerequisite
to all other configurations. For the detailed configuration procedure, refer to Device
Management in the resource management part.

2.

Adjust parameters.

After the MPLS TE devices are imported to the system, the system will display the configuration
information of the devices on the device management page. You may need to adjust some
of the device configurations, such as the device CR-LSP tie-breaking policy and the traffic
forwarding parameters. For the detailed configuration procedure, refer to Device Management
and Interface Management in the resource management part.

3.

Configure explicit path (optional).

This step is not necessary in static CR-LSP tunnel configuration, and is optional in dynamic
tunnel configuration. An explicit path consists of a series of nodes and is used to restrict the
path that a tunnel is to pass. When configuring a tunnel, you can reference a configured
explicit path. For the detailed configuration procedure, refer to Explicit Path Management.

4.

Configure tunnel.

After the above configuration, you can configure a tunnel. The system allows you to configure
an MPLS TE tunnel using static CR-LSP or a dynamic signaling protocol. Configuring an MPLS
TE tunnel through a static CR-LSP is simple. It requires no tunnel constraints and involves no
TE extension of any IGP or CSPF calculation. Configuring a tunnel through a dynamic signaling
protocol is relatively complicated. However, the dynamic signaling protocol can dynamically

100 MPLS TE manager