ADC Release 3.1 - Manual (Page 335)

1152700 • Issue 1 • February 2001 • Section 2 Operations and Maintenance
Page 2-315
© 2000, ADC Telecommunications, Inc.
DLP-774
Page 4 of 4
TELNET TO THE NMIC
15. At this point it is necessary to telnet back to the NMIC after it reboots. Following the log in
process, the Run command for your particular application will initialize the configuration
of the NMIC system files. The commands listed in Table 747-3 can be entered in the
sequence shown from the UNIX PROMPT.
Table 774-3. Telnet and Configuration Initialization
COMMAND DEFINITION
Telnet (name given NMIC) Following the telnet command, enter the actual name given
to the NMIC.
Export TERM=vt100 If working from pc/laptop, enter this command.
Export DISPLAY=(IP address) IP address is of machine you are working from.
Start, Run, winipcfg
-or-
ipconfig
–or-
/sbin/ifconfig –a
–or-
/usr/sbin/ifconfig –a For Windows 95 and 98, this will start the configuration.
To find in Windows NT go to DOS prompt and enter command.
To find in a Linux operating system, enter this command.
To find in a Solaris operating system, enter this command.
16. Look for Ethernet Zero address: INET address plus:0+0
17. Enter the following command to launch the Cellworx Vision Graphical User Interface:
“CellworxVision”
18. Follow GUI
Stop! You have completed this procedure.