ADC Release 3.1 - Manual (Page 292)

1152700 • Issue 1 • February 2001 • Section 2 Operation and Maintenance
Page 2-272
© 2000, ADC Telecommunications, Inc.
DLP-761
Page 1 of 3
RETRIEVE T3 CRS CARD STATUS
Summary: This procedure defines the information retrieved from the shelf level GUI display for
the T3 CRS card status. User must have the GUI launched and accessed the shelf level GUI
display per NTP-007 prior to performing this procedure.
1. Double click on the T3 CRS card located in the shelf level GUI “Chassis View” at the top of
the window.
2. Click the small block between the Status and Configuration sections and drag it downward
to view all the status information. Refer to Table 761-1 for definitions of status information
provided.
3. Select each port on the card to view the statuses.
4. Select the Close button at the bottom of the window to close the screen and return to the
chassis level display.
Stop! You have completed this procedure.
Cellworx Vision: Card View - T3 CellRelay Service
Status:
Apply Chassis View Refresh Close
X
Card Level
Operational State:
Availability State:
Protection State:
Port Level
NE Name: Cellworx1
NE Id: 1
Card: T3 CRS
Slot Number: 8
Port Number: 1
Status
Active
Protect
1
2
3
Port
ADC
T3
CRS
Up
Availabli
Not Protected
Line State:
No Alarm
RCV RAI Failure
Xmt RAI Alarm
Rcv AIS
TC Alarm Status: No Alarm
Configuration:
Port Level
Timing
Xmit AIS
LOF
LOS
Loopback State
Rcv Test Code
Other Failure
PLCP Alarm Status: No Alarm
APPLIES CHANGES
AND SENDS TO SHELF
CONTROLLER. RETURNS TO CHASSIS
VIEW WITHOUT CLOSING
CARD LEVEL VIEW. REPAINTS WINDOW
TO REFLECT ANY
CHANGES. CLOSES CARD LEVEL
VIEW AND RETURNS TO
SHELF LEVEL VIEW.
CLICK ON BOX AND DRAG
UP OR DOWN TO EXPAND
STATUS OR CONFIGURATION
VIEWS.
13451-B
Figure 761-1. T3 CRS Card Status Window