ADC Release 3.1 - Manual (Page 141)

1152700 • Issue 1 • February 2001 • Section 2 Operation and Maintenance
Page 2-121

2000, ADC Telecommunications, Inc.
DLP-718
Page 1 of 1
REFRESH TOPOLOGY
Summary: This procedure describes the steps required to refresh the display of the network
nodes. This is done after any changes to the view of the network have been modified such as
adding or deleting nodes, moving the positions of a node, changing connections between the
nodes, or changing node names.
1. Select the Configuration pull down menu, Topology, and Refresh using the left mouse
button or by hitting Alt+C, Alt+T, and Alt+R. Refer to Figure 718-1 .
2. The system responds with a message window stating that it is updating the topology, and to
please wait. Refer to Figure 718-2 .
3. A refresh may also be initiated using the icon shown in Figure 718-3 .
Stop! You have completed this procedure.
Cellworx Vision Subnetwork Management System
File Configuration Fault Performance
Software
NMIC Platform
Topology
Time and Date
Connection
10978-E
Refresh...
Remove Expansion Shelf Network Element
Remove Ring Network Element
Add Expansion Shelf Network Element
Add Ring Network Element
Force Network Discovery ...
Turn Up Ring...
Revert to Saved Icon Layout...
Ring Audit
Ring Upgrade
Figure 718-1. Cellworx Vision Configuration Pull Down Menu
Updating topology. Please wait...
11015-A
Figure 718-2. Cellworx Vision GUI Updating Topology
E
REFRESH
TOPOLOGY
11916-B
Figure 718-3. Refresh Topology Icon on NMIC GUI