NORD Drivesystems BU0700 - Manual (Page 98)

NORDAC SK 700E Operating Manual
98 Subject to technical alterations BU 0700 GB-1411
5.1.7 Positioning
For the description of parameter P6xx please refer to the instructions BU 0710. (www.nord.com)
5.1.8 Information
Parameter Setting value / Description / Note Available with option
P700 Current fault always visible
0.0 ... 20.9 Actual error present. Further details in Chapter 6 Error messages.
ControlBox: Descriptions of the individual error numbers can be found in the point Error messages.
ParameterBox: Errors are displayed in plain text, further information can be found in the point Error
messages.
P701 .. - 01
...
.. - 05
Last fault 1...5 always visible
0.0 ... 20.9 This parameter stores the last 5 errors. Further details in Chapter 6 Error messages.
The ControlBox must be used to select the corresponding memory location 1-5 (Array), and confirmed
using the ENTER key to read the stored error code.
P702 .. - 01
...
.. - 05
Frequency last error 1...5 always visible
-400.0 ... 400.0 Hz This parameter stores the output frequency that was being delivered at the time the fault occurred. The
values of the last 5 errors are stored.
The ControlBox must be used to select the corresponding memory location 1-5 (Array), and confirmed
using the ENTER key to read the stored error code.
P703 .. - 01
...
.. - 05
Current last error 1...5 always visible
0.0 ... 500.0 A This parameter stores the output current that was being delivered at the time the fault occurred. The
values of the last 5 errors are stored.
The ControlBox must be used to select the corresponding memory location 1-5 (Array), and confirmed
using the ENTER key to read the stored error code.
P704 .. - 01
...
.. - 05
Voltage last error 1...5 always visible
0 ... 500 V This parameter stores the output voltage that was being delivered at the time the fault occurred. The
values of the last 5 errors are stored.
The ControlBox must be used to select the corresponding memory location 1-5 (Array), and confirmed
using the ENTER key to read the stored error code.
P705 .. - 01
...
.. - 05
DC-link voltage last error 1...5 always visible
0 ... 1000 V This parameter stores the link voltage that was being delivered at the time the error occurred. The
values of the last 5 errors are stored.
The ControlBox must be used to select the corresponding memory location 1-5 (Array), and confirmed
using the ENTER key to read the stored error code.