NORD Drivesystems BU0700 - Manual (Page 36)

NORDAC SK 700E Operating Manual
36 Subject to technical alterations BU 0700 GB-1411
Menu structure with the SimpleBox
P0 - -
_ _ _ _
P1- -
P2- -
P4 - -
P5- -
P6 - -
P7- -
P0 0 1
P0 0 2
P10 0
P10 1
P114
P20 0
P20 1
P216
P40 0
P40 1
P460
Operating values display
(or operational)
following mains ON
P3- -
P30 0
P30 1
P330
To change a parameter value, the ENTER key must be pressed when the applicable parameter number is displayed.
Changes can then be made using the VALUE keys or and must be confirmed with to save them and leave the
parameter.
As long as a changed value has not been confirmed by pressing ENTER, the value display will flash; this value has not yet been
stored in the frequency inverter.
During parameter changes, the display does not blink so that the display is more legible.
If a change is not to be saved, the "DIRECTION" key can be pressed to leave the parameter.
vector
R
Accept changed values
Value to factory setting
Increase value Reduce value
Do not save changed
value
Parameter set display