Dwyer PSX2 - Manual (Page 91)

82
(9) Press the ENT key to move the cursor to the set item
“CONTINUOUSNESS” or “APPOINT TIME”.
• Setting of “CONTINUOUSNESS”
Sets the start time, the fi nish time, and the logging
cycle.
Move the cursor to “START” and press the ENT key to
start logging.
• Setting of “APPOINT TIME”
Sets the logging period, the start/fi nish time, and the
logging cycle.
Move the cursor to “START” and press the ENT key to
start logging.
• If the output unit or system unit was changed after logger start, logging is performed in the
unit at the time of start. The changed unit becomes valid after the logger is stopped.
• Start-up is not permitted if the set time is later than the time of the main unit clock. Make sure
to set a time with a margin of several minutes after the present time.
CAUTION
Bulletin F-9-PUX2