Dwyer PSX2 User Manual

Page 69

(8) Quick logger

Logger can be started from the measurement screen. For logger function by timer operation,
refer to “10.2.3 LOGGING”.
Note) It cannot be started during data logging.

: Logger started

: Logger stopped

: Cannot be started

(9) Status display

Displays the current status. In case more than one error is displayed, the

is indicated at the

far right.
Check if “NORMAL” is displayed.If the sensor is not connected, other messages may be dis-
played. This is not an error.
In case another message is displayed after installing and connecting the sensor, take corrective
actions according to page 140, “10.8 Contents of error in status display”.
If “NORMAL” is not displayed when 1 or less indicator is display, refer to page 147, “12.3 Er-
ror in measured value”.

(10) Kind of measurement

When changing the kind of measurement on the
measurement screen:
Flow rate, velocity, total display can be changed
on the measurement screen.

• Move the cursor to the measurement screen to

be changed.

• Press the

ENT

key, and the screen appears,

enabling the kind of measurement to be

selected. Select any kind of measurement by

the

key and then press the

ENT

key.

(11) Flow rate

When changing the ﬂ ow rate on the measure-
ment screen:
Unit of ﬂ ow rate may be changed on the mea-
surement screen.

• Move the cursor to the unit of ﬂ ow rate to be

changed.

• Pressing

key, move the cursor to the

unit of ﬂ ow rate you want to change.

• Press the

ENT

key, and the screen appears,

enabling the unit of ﬂ ow rate to be selected.

Select any unit by pressing the

key

and then press the

ENT

key.

(12) Unit of total

When changing the unit of total, refer to page 67 “UNIT OF OUTPUT”.

Bulletin F-9-PUX2

This manual is related to the following products:

PUX2