Dwyer PSX2 - Manual (Page 89)

80
10.2.3 LOGGING: when logging (recording) measured data
[Operation]
(1) Press the or key on the LOGGING screen to
select “LOGGING” and press the ENT key.
“LOGGING” only sets logging conditions.
To start logging, follow the steps (2) to (8) given shown below.
(3) Register the place or the pipe name for logging.
Refer to Page 24 and 25 to enter characters.
(2) Register the name of the logger.
Press the ENT key after the cursor is placed in the
“NAME”.
The cursor moves to the character entry fi eld.
(4) Select the kind of data to be logged.
Move the cursor pointed from “NAME” to “KIND”
by the
key.
Then, press the ENT key, and the cursor moves to
kinds of data.
Bulletin F-9-PUX2