Dwyer PSX2 - Manual (Page 113)

104
“FEEDING TEMP” : Sets the feeding temperature.
When you select “ANALOG INPUT
CHANNEL1”, current input of CH1
is set to returning temperature.
Set the 10.3.2(1) Input CH1 of clause
defi nition to “CURRENT INPUT
(FEEDING TEMP.)”.
When you set the defi nition of In-
put CH2 to the “CURRENT INPUT
(DIFFEREN TEMP.)”, the FEEDING
TEMP. will be disabled.
When you select “TEMPERATURE
SETTING”, the temperature you
entered is set to feeding temperature.
Setting range : –20 to 120ºC
“MODE” : Select the “CALORIE MODE”.
When you select “NOT USED”, calo-
rie is not measured.
“OPERATION” : Sets the environment for the pipe to be
measured. Select from the menu for
setting.
* Not cooling/heating operation (when
you select “OTHERS”, set the conver-
sion coeffi cient of heat quantity.)
Setting range: 1.000 to 9.999
“FLUX MEASUREMENT”:
Sets the position to measure the fl ow
rate of heating medium.
Bulletin F-9-PUX2