Dwyer PSX2 - Manual (Page 103)

94
(6) MEMORY INITIALIZE: The setting parameters are initialized.
[Operation]
(1) Press the or key on the BASIC SETUP screen
and select “MEMORY INITIALIZE”.
Press the
ENT
key, and you are ready to initialize the
data.
NOTE) The following data will be retained.
(1) The site that has been not selected in
site memory
(2) Clock
(3) Analog output/ input calibration value
(4) The contents of SD memory card
CAUTION
(2) Select “INITIALIZE” by pressing the or key
and press the
ENT
key.
When the parameter is initialized, display
language is set to English.
For changing display language, refer to “5.2
Turning on power and language preference”.
CAUTION
(3) Select “To Execute” by pressing the or key and
press the
ENT
key.
Bulletin F-9-PUX2