Replacement of built-in battery, Caution – Dwyer PSX2 User Manual
Page 164
155
15. REPLACEMENT OF BUILT-IN BATTERY
(1) Turn off the power supply of main unit.
(2) Remove the rubber guard.
(3)
Locate 4 screws at the corners of the back cover diagram label.
Remove the 4 screws and cover as shown.
(4) Remove the battery and replace it with the appropriate service part.
Note) Install a combination of the main unit side terminal and the battery side terminal.
ĺ
ĺ
• Do not give the equipment a shock
• Do not disassemble or modify the equipment
• Do not use the equipment with the built-in battery removed.
CAUTION
Bulletin F-9-PUX2
This manual is related to the following products:
See also other documents in the category Dwyer Accessories for air:
- 166T (1 page)
- 160S (2 pages)
- PAFS-1000 (1 page)
- 160F (2 pages)
- Mark II WSI (4 pages)
- MW-1 (2 pages)
- 89088 (12 pages)
- 660 (2 pages)
- 670 (16 pages)
- FLST (4 pages)
- AFG (6 pages)
- FAFM (2 pages)
- DAFM (2 pages)
- STRA (4 pages)
- 530 (2 pages)
- AVFS (2 pages)
- 641RM (4 pages)
- 641B (4 pages)
- 641 (4 pages)
- VTT (2 pages)
- SFI-700 (2 pages)
- GFM (32 pages)
- GFC (40 pages)
- DMF (44 pages)
- GFM2 (20 pages)
- GFM3 (22 pages)
- TFP-LI (30 pages)
- TFP-GI (27 pages)
- TBS (7 pages)
- HFT (4 pages)
- CAM (6 pages)
- PWD (3 pages)
- BAT (3 pages)
- FPCA (4 pages)
- FPCA (2 pages)
- SPK (4 pages)
- MFS (8 pages)
- LOFM (3 pages)
- FLMG (12 pages)
- MFS2 (16 pages)
- PFT (4 pages)
- IPFS (7 pages)
- UFB (48 pages)
- UFC (56 pages)
- Series PUB (44 pages)