Dwyer PSX2 - Manual (Page 102)

93
(5) MEASURE METHOD: when changing measurement method
NORMAL is the standard measurement method.
ANTI-DISTURBANCE MODE resists an external disturbance.
If the MODE is not available, change it to the ANTI-DISTURBANCE MODE.
The measurement system is automatically selected according to the kind of sensor or setting
of outer diameter. If the ANTI-DISTURBANCE MODE is automatically selected from the
beginning, there is no need to switch the method. For the MODE that has been automatically
selected, change to the ANTI-DISTURBANCE MODE is possible.
[Operation]
(1) Press the or key on the BASIC SETUP screen
and select “MEASURE METHOD”.
Press the
ENT
key, and the screen appears, prompting
you to select measurement method.
The measurement method is initialized according to the kind of sensor or outer diameter set-
ting at the power ON or just when the PROCESS SETTING screen is displayed on the SITE
SETTING. After changing from NORMAL to ANTI-DISTURBANCE MODE, the unit will
set the measurement method again when the power is turned OFF or the PROCESS SETTING
screen is displayed.
CAUTION
(2) Select “NORMAL” or “ANTI-DISTURBANCE
MODE” by the or key and press the
ENT
key.
When the measurement method has been changed from NORMAL to ANTI-DISTURBANCE
MODE, measurement values are subjected to change.
CAUTION
Bulletin F-9-PUX2