Dwyer PSX2 - Manual (Page 120)

111
(4) Set “BURNOUT TIMER”
Setting range: 0 to 900sec
Select “BURNOUT TIMER” by pressing the
or
key.
Press the
ENT
key, and you are ready to set the time.
(5) Move the digit by the or key and enter numeric
values by pressing the or key.
After entry, press the
ENT
key.
• HOLD: Holds output indications before the
occurrence of errors.
• UPPER: 10.4.2(1) the setting of "Output limit
high" is output.
• LOWER: 10.4.2(1) the setting of "Output limit
high" is output.
• ZERO: Outputs (0%, 4 mA) at zero point
Bulletin F-9-PUX2