Seed Hawk Raven 2010 User Manual

Page 55

Manual No. 016-3001-003

CAN (Controller Area Network) Setup

Tank Volume

Enter the estimated volume of product in the tank. This value must be reset each time the tank is refilled. The

Low Tank Alarm feature is based upon the value entered in this field.

Review the Low Tank section on page 33 for information about setting the Low Tank Alarm. See the Tally
Registers

section on page 53 for information on resetting the tank volumes to a preset value.

Rate Cal

Enter the target rate for the product controlled via the selected product node.

Rate Bump (+/-)

The rate bump setting is the value which the target rate is increased or decreased by toggling the INC/DEC

switch on the Seed Hawk switch box.

See the Application Rates section on page 69 for more information about the Application Rates Area on the

main screen and using the rate bump feature during a field application.

Meter Cal/Density

Depending upon the selected application type, either the meter cal or density setting will be displayed in Data

Box 2. See the Application Area section on page 51 for information about setting the type of product

application.

For liquid product application, the meter cal must be entered to calibrate the Viper Pro to the specific flow

meter used to measure product application. The meter cal value is typically found on the flow meter.

For granular products, enter the product density or weight of 1 cubic foot of product in the density setting. The

density of the product must be entered to calibrate the Viper Pro to the weight of product being applied.

Spreader

For granular applications, the specific spreader constant for your gate vehicle’s setup must be entered in this

field.

Note:

Enter a zero in this field when applying liquid products.